Gmail Calendar Documents Reader Web more »
Recently Visited Groups | Help | Sign in
Google Groups Home
aus.radio.amateur.misc
+ new post
About this group
Subscribe to this group
This is a Usenet group - learn more
Message from discussion SSTV SETUP
The group you are posting to is a Usenet group. Messages posted to this group will make your email address visible to anyone on the Internet.
Your reply message has not been sent.
Your post was successful
 
From:
To:
Cc:
Followup To:
Add Cc | Add Followup-to | Edit Subject
Subject:
Validation:
For verification purposes please type the characters you see in the picture below or the numbers you hear by clicking the accessibility icon. Listen and type the numbers you hear
 
Kate  
View profile  
 More options Jun 27, 8:12 am
Newsgroups: aus.radio.amateur.misc
From: "Kate" <vk4...@nospam.no.way>
Date: Sat, 27 Jun 2009 08:12:14 +1000
Local: Sat, Jun 27 2009 8:12 am
Subject: Re: SSTV SETUP
Reply to author | Forward | Print | View thread | Show original | Report this message | Find messages by this author

"PJ" <rredb...@optusnet.com.au> wrote in message

news:4a44a915$0$32004$afc38c87@news.optusnet.com.au...

> "Kate" <vk4...@nospam.no.way> wrote in message
> news:4a43d9fb$0$7111$afc38c87@news.optusnet.com.au...

>> "PJ" <rredb...@optusnet.com.au> wrote in message
>> news:4a43543b$0$3253$afc38c87@news.optusnet.com.au...
>>> Hi guys,looking for transmitter setup for sstv. what power can be used
>>> please?

>>> Im used to PSK31 setup with alc and power setup,but new to sstv..

>>> Any help please ?? Cheers  PJ
>> As it's a full cycle mode, it's best to use a low power setting. I run my
>> TS 50S at 25 watts usually and 50 if I need to punch a signal through the
>> noise. Running at full power for every tx will do your finals in!

>> Kate vk4xyl
>i got a mk11g but i imagine the duty cycle would be similar to the TS50.
>What about ALC ,or,lack of it as in psk31 ??

> Ty Kate.. Cheers.. PJ

Haven't got alc on the 50, since the audio is fed to the SignaLink from the
rear audio output jack, I use the main vol control on the rig to set the
level, using the level indicator in MMSSTV. Since that results in the audio
only going to the computer, I built a small doubler box with switch to get
audio into a speaker, on/off as required.

The computer's audio level controls can also be used to set levels of
incoming audio and output level for correct drive of the vox circuit in the
SignaLink. Most of the correct settings can be determined by
experimentation.

Kate vk4xyl


    Reply to author    Forward  
You must Sign in before you can post messages.
To post a message you must first join this group.
Please update your nickname on the subscription settings page before posting.
You do not have the permission required to post.
Create a group - Google Groups - Google Home - Terms of Service - Privacy Policy
©2009 Google