> Hi guys,looking for transmitter setup for sstv. what power can be used > please?
> Im used to PSK31 setup with alc and power setup,but new to sstv..
> Any help please ?? Cheers PJ
As it's a full cycle mode, it's best to use a low power setting. I run my TS 50S at 25 watts usually and 50 if I need to punch a signal through the noise. Running at full power for every tx will do your finals in!
>> Im used to PSK31 setup with alc and power setup,but new to sstv..
>> Any help please ?? Cheers PJ > As it's a full cycle mode, it's best to use a low power setting. I run my > TS 50S at 25 watts usually and 50 if I need to punch a signal through the > noise. Running at full power for every tx will do your finals in!
>>> Im used to PSK31 setup with alc and power setup,but new to sstv..
>>> Any help please ?? Cheers PJ >> As it's a full cycle mode, it's best to use a low power setting. I run my >> TS 50S at 25 watts usually and 50 if I need to punch a signal through the >> noise. Running at full power for every tx will do your finals in!
>> Kate vk4xyl >i got a mk11g but i imagine the duty cycle would be similar to the TS50. >What about ALC ,or,lack of it as in psk31 ??
> Ty Kate.. Cheers.. PJ
Haven't got alc on the 50, since the audio is fed to the SignaLink from the rear audio output jack, I use the main vol control on the rig to set the level, using the level indicator in MMSSTV. Since that results in the audio only going to the computer, I built a small doubler box with switch to get audio into a speaker, on/off as required.
The computer's audio level controls can also be used to set levels of incoming audio and output level for correct drive of the vox circuit in the SignaLink. Most of the correct settings can be determined by experimentation.
>>>> Im used to PSK31 setup with alc and power setup,but new to sstv..
>>>> Any help please ?? Cheers PJ >>> As it's a full cycle mode, it's best to use a low power setting. I run >>> my TS 50S at 25 watts usually and 50 if I need to punch a signal through >>> the noise. Running at full power for every tx will do your finals in!
>>> Kate vk4xyl
>>i got a mk11g but i imagine the duty cycle would be similar to the TS50. >>What about ALC ,or,lack of it as in psk31 ??
>> Ty Kate.. Cheers.. PJ
> Haven't got alc on the 50, since the audio is fed to the SignaLink from > the rear audio output jack, I use the main vol control on the rig to set > the level, using the level indicator in MMSSTV. Since that results in the > audio only going to the computer, I built a small doubler box with switch > to get audio into a speaker, on/off as required.
> The computer's audio level controls can also be used to set levels of > incoming audio and output level for correct drive of the vox circuit in > the SignaLink. Most of the correct settings can be determined by > experimentation.
|
